Effect of Varying Ageing Time on the Thermal Properties of Al-7.5%Si-0.45%Mg Alloy for Brake Disc Application
Article PDF

Keywords

Chill casting, Solution heat treatment, Ageing time, Aluminium alloy, Differential scanning calorimetry, thermogravimetric study

How to Cite

Waziri, A. B., Haruna, M., Umaru, O. B., Mohammed, N., Azi, M. D., & James, G. N. (2025). Effect of Varying Ageing Time on the Thermal Properties of Al-7.5%Si-0.45%Mg Alloy for Brake Disc Application. Engineering Research Journal, 5(3), 58-69. https://www.openjournals.ijaar.org/index.php/erj/article/view/1454

Abstract

An investigation of the thermal analysis on Al-7.5%Mg-0.45%Si alloy for its application in brake disc have been investigated. The alloy was produced using the chill casting method and solution heat treated to 540oC for 1 hour, quenched in warm water (60oC) followed by ageing at 180oC for 1-5 hours respectively. The analysis performed on the heat treated/non-heat-treated alloy was Differential Scanning Calorimetry (DSC)/Thermogravimetry analysis (TGA) and Scanning Electron Microscopy (SEM)/X-ray Diffractometry (XRD) analysis respectively. Results of the DSC/TGA analysis showed the formation of precipitates which became harder with increasing ageing time thereby improving the thermal condition of the material. The SEM/XRD analysis further showed these precipitates to include Al9Si, AlFeMg3Si6, Al8FeMg3Si6, Al12Mg17, CrFe4, Al9Si, Al8Cr5, Mg2Si and Al15(Mn, Fe)3Si2. The weight loss in the material was lowest after 3 hours with 3.5% and 2.5% loss in the first and second degradation, while the control samples recorded 6% and 5% weight loss. The improvement for the heat-treated sample is as a result of diffusion of precipitates and homogenization of the matrix. In conclusion, the heat treatment performed have shown that over ageing of the samples can increase the loss in weight due to the loss in the strength of the material investigated.

Article PDF
Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Copyright (c) 2025 Engineering Research journal

377 171