Empirical Estimation of Coefficients of Cutting Force Parameters in Turning Process
Article PDF

Keywords

Empirical estimation
cutting force
turning process
feed rate
cutting speed
depth of cut
optimization

How to Cite

Bereprebofa, D., Ikpeseni, S., Sinebe, J., & Ekpu, M. (2025). Empirical Estimation of Coefficients of Cutting Force Parameters in Turning Process. Engineering Research Journal, 5(1), 45-56. https://www.openjournals.ijaar.org/index.php/erj/article/view/980

Abstract

This study presents an empirical approach to estimate the coefficients of cutting force in turning processes. Cutting forces play crucial role in machining, affecting tool life, surface finish and overall productivity. Accurate estimation of cutting force coefficients is essential for optimizing machining parameters. Using experimental data from turning operation on AISI 1045 (steel) a regression model was developed to predict cutting force coefficients. A design matrix was constructed by applying the CCD. Response Surface Methodology (RSM) in design expert software was used to run the regression model. Analysis of Variance (ANOVA) was used to determine the significance of the model and its parameters. The results showed that cutting speed, feed rate, and depth of cut significantly influence cutting force. The result also revealed 8.68, 10.87 and 10.12 are the coefficients of cutting speed, feed rate and depth of cut respectively. Also, high R2 value of 0.8337 of the plot of predicted and actual values indicates the model can accurately predict cutting force with low values of variance inflation factors (VIFs) between 1.0 – 1.02 (less than 10). The proposed empirical model provides a practical tool for cutting force coefficients, enabling machinists to optimize turning process parameters for improved efficiency and productivity.

Article PDF
Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Copyright (c) 2025 Engineering Research journal

364 368