Integration of Geotechnical and Geographical Information System-Based Approaches for Investigation of Road Failure Along Bauchi – Gombe Highway in Nigeria
Article PDF

Keywords

Highways, Geographical Information System, California Bearing Ratio, Hydraulic Conductivity, Spatial Analysis

How to Cite

Popoola, M. S., Umaru, I., & Haruna, Y. G. (2025). Integration of Geotechnical and Geographical Information System-Based Approaches for Investigation of Road Failure Along Bauchi – Gombe Highway in Nigeria. Engineering Research Journal, 5(4), 64-80. https://doi.org/10.5281/zenodo.17981158

Abstract

This study employs an integrated approach combining geotechnical engineering methods and Geographical Information System (GIS) technology to investigate and analyze road failure mechanisms along Bauchi – Gombe Highway in Nigeria. The following laboratory tests were carry out on the soil at failure zones of the road: Moisture content test, Specific gravity test, Atterberg limits, Particle size distribution (sieve analysis) test, Compaction test, CBR test, Permeability test, CBR test and Asphalt extraction test and oxide composition tests The Natural Moisture Content across the pits varied between 2.5% and 13.2%, reflecting heterogeneous soil conditions. Specific gravity ranged between2.45–2.68, clustered near 2.60–2.65, typical of quartz-dominated sandy/silty residual soils. Across the ten pits, Liquid limit spanned14 – 43% and PI 0 – 23%, indicating predominantly low-to-moderate plasticity with one higher-plasticity location. Pit 3R (LL = 43%, PI = 23%) stands out as highly plastic, implying active clay minerals. Most samples were AASHTO A-2 granular soils with fines (A-2-4, A-2-6, A-2-7), while one was a high-plasticity clayey soil (A-7-6 at Pit 3R). By USCS, the profile was dominated by SM (silty sand) and SC (clayey sand), with one SW-SM (well-graded sand with silt) at Pit 8L. The Maximum Dry Density (MDD) values between 1.97–2.17 Mg/m³ and Optimum Moisture Content values 5.3–10.3% were recorded. The accepted California Bearing Ratio (CBR) values spanned13–75%, showing a wide spread in subgrade support capacity across the corridor. By the Federal Ministry of Works criteria CBR for sub-grade should be ≥13%, sub-base should be ≥30%and for road-base ≥80%, withr≥30%elative compaction of 100%. Permeability values ranged from 3.08×10⁻⁹ to 1.01×10⁻⁷ m/s, indicating very low hydraulic conductivity typical of fine-grained, fines-rich sands/silts and clayey sands. The GIS analysis revealed that the major source of floodwaters damaging the Bauchi–Gombe road and associated hydraulic structures originates from the Yankari Game Reserve catchment. The findings provide a scientific basis for designing robust, region-wide mitigation measures that not only protect the Bauchi–Gombe highway but also enhance the ecological balance of the Yankari catchment.

Article PDF
Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Copyright (c) 2025 Engineering Research journal

312 92